6mm – .338 Controlled Depth Tapered Reamer

(4 customer reviews)

$62.95

The K&M case mouth chamfer tool cuts a shallow angle chamfer on the inside of the case neck for smooth bullet seating while controlling the depth of cut with stop fingers that register on the case mouth which insures each case has the same depth chamfer.  The chamfer angle is 4 degrees per side.  The tool also incorporates a pilot pin that guides through the flash hole of the cartridge to maintain the tool on the centerline of the cartridge for an even cut. 

Note: Additional images shown with available accessories

In stock

SKU: CDTR6338 Category:

Description

6mm – .338 Controlled Depth Tapered Reamer – Reloading Chamfer Tool

The K&M case mouth chamfer tool cuts a shallow angle chamfer on the inside of the case neck for smooth bullet seating while controlling the depth of cut with stop fingers that register on the case mouth which insures each case has the same depth chamfer.  The chamfer angle is 4 degrees per side.  The tool also incorporates a pilot pin that guides through the flash hole of the cartridge to maintain the tool on the centerline of the cartridge for an even cut.  The tools cut chatterless by means of a 6-flute cutting design except for the .17cal-6mm tool which is a 3-flute tool.  We now have 5 tools in the line up to accommodate calibers .17 through .50 caliber.

  • .17cal – 6mm Calibers
  • 6mm – .338 Calibers
  • .35 – .408 Calibers
  • .416 – .50 calibers
  • .416 – .50 Calibers, BMG Cartridges base only

 


 

Tool Notes:

how to tapered reamer case mouth chamfer correction tool case neck chamfering

download our user guide

User Guide Download

  1. Size your brass before using this reloading chamfer tool to ensure that the case mouth inside diameter is consistent and perfectly round.
  2. Loosen the thumbscrew and use a small flat blade screwdriver to adjust the set screw in the handle to move the cutter within the tool body. It is best to start with the cutter set so it is not touching the case mouth and begin inching it forward with the set screw until you just make contact with the case mouth, now advance the cutter forward until the desired chamfer depth is attained and tighten the thumbscrew.
  3. Typical chamfer depth is .015”-.030”.
  4. The cutter is sharp so remove material gently until the stop fingers make contact with the case mouth. This usually only takes 2 or 3 revolutions between your thumb and forefinger.
  5. Bullet will now seat smoothly with its base unharmed.

4 reviews for 6mm – .338 Controlled Depth Tapered Reamer

  1. Bill in Tampa

    Best chamfering tool I’ve ever used.

    This tool leaves no chatter marks and is perfectly even around the circumference of the neck. Each neck is exactly the same depth. Positions bullet in the exact center of the case & does not cause distortion of neck when seating.

  2. Mike Jones (verified owner)

    The shallow cut makes for very smooth bullet seating. A+

  3. Frank Kalisz (verified owner)

    It’s a fantastic little tool to get a shallow and uniform chamfer on inside neck mouth. Adjusting was simple, and just a light twist twist is enough to get a precise and uniform chamfer on all my brass. It’s much easier to use than any conventional chamfer/debur tool.

  4. Monte Mlekush (verified owner)

    Like everything else from K&M, the chamfering tool is of the highest quality and easy to use. Super easy to adjust. (I actually read the instructions)

Add a review