.17 – 6mm Controlled Depth Tapered Reamer

(3 customer reviews)

$62.95

The K&M case mouth chamfer tool cuts a shallow angle chamfer on the inside of the case neck for smooth bullet seating while controlling the depth of cut with stop fingers that register on the case mouth which insures each case has the same depth chamfer.  The chamfer angle is 4 degrees per side.  The tool also incorporates a pilot pin that guides through the flash hole of the cartridge to maintain the tool on the centerline of the cartridge for an even cut. 

Note: Additional images shown with available accessories

In stock

SKU: CDTR176 Category:

Description

.17 – 6mm Controlled Depth Tapered Reamer

The K&M case mouth chamfer tool cuts a shallow angle chamfer on the inside of the case neck for smooth bullet seating while controlling the depth of cut with stop fingers that register on the case mouth which insures each case has the same depth chamfer.  The chamfer angle is 4 degrees per side.  The tool also incorporates a pilot pin that guides through the flash hole of the cartridge to maintain the tool on the centerline of the cartridge for an even cut.  The tools cut chatterless by means of a 6-flute cutting design except for the .17cal-6mm tool which is a 3-flute tool.  We now have 5 tools in the line up to accommodate calibers .17 through .50 caliber.

  • .17cal – 6mm Calibers
  • 6mm – .338 Calibers
  • .35 – .408 Calibers
  • .416 – .50 calibers
  • .416 – .50 Calibers, BMG Cartridges base only

 


 

Tool Notes:

how to tapered reamer case mouth chamfer correction tool case neck chamfering

download our user guide

User Guide Download

  1. Size your brass before using this tool to insure that the case mouth inside diameter is consistent and perfectly round.
  2. Loosen the thumb screw and use a small flat blade screw driver to adjust the set screw in the handle to move the cutter within the tool body. It is best to start with the cutter set so it is not touching the case mouth and begin inching it forward with the set screw until you just make contact with the case mouth, now advance the cutter forward until the desired chamfer depth is attained and tighten the thumb screw.
  3. Typical chamfer depth is .015”-.030”.
  4. The cutter is sharp so remove material gently until the stop fingers make contact with the case mouth. This usually only takes 2 or 3 revolutions between your thumb and fore finger.
  5. Bullet will now seat smoothly with its base unharmed.

3 reviews for .17 – 6mm Controlled Depth Tapered Reamer

  1. bigwsky (verified owner)

    This is the ticket to get a perfect chamfer on fresh trimmed brass.
    It gives you a perfect and repeatable bevel on the case mouth.
    This by far one of my favorite precision brass preparation tools. I wish I would have bought on sooner.
    If you haven’t tried K&M tools before,
    I would suggest giving this one a try.

  2. bigwsky (verified owner)

    I like the .17-6mm chamfer tool so much, I purchased the 6mm-338 chamfer tool.
    Perfect chamfer every time.

  3. its.me.thomas.g (verified owner)

    It’s a beautiful little tool. It puts a perfect chamfer on the neck so even flat based bullets will sit in the neck perfectly. Definitely don’t regret purchasing it, and I don’t think you would either!

Add a review